Corrected from:
PLC Designer V3.3.2
Response of the new version:
Started measurements can be stopped in the 'Oscilloscope' tab even if the tab has meanwhile been closed.
What happens?
A measurement which has been started in the 'Ocilloscope' tab cannot be stopped. The <Stop> button is inactive.
When does the problem occur?
If a measurement is started in the 'Oscilloscope' tab and if this tab is closed afterwards although the measurement in the device has not been completed it is impossible to stop the running measurement when re-opening the tab.
Which products are affected?
PLC Designer V3.3
i700 servo inverter
Possible diagnostics?
None.
Short-term measures/recommendations:
? Do not close the tab while the measurement is running. However, it is still possible to change the tabs without problems.
? If you have closed the tab do not reopen it before the measurement has been finished.
? Carry out mains switching of the i700 servo inverter if e.g. a set trigger value has not been reached during the measurement.
Evaluation:
If a measurement in the i700 servo inverter is started in the 'Oscilloscope' tab, this measurement cannot be stopped if the tab has been closed in the meantime.