ECSxM can be appended to the EtherCAT master of the Lenze controller (corrected from PLC Designer V3.8)

Corrected from:
PLC Designer V3.8

Response of the new version:
With PLC Designer V3.8, the "ECSxM Motion" compact servo can no longer be appended to the EtherCAT master of the 3200C or p500 controller.


What happens?
The "ECSxM Motion, ETC module V1" can be appended to the EtherCAT master of the 3200C and p500 controller in the PLC Designer.

When does this behaviour occur?
From control system release V3.6 onwards, the Lenze 3200C and p500 controllers (firmware V3.6)  no longer support the ECSxM compact servo at their EtherCAT interface for new configuration. It is, however, still possible to append the ECSxM in PLC Designer V3.6 to the EtherCAT master of the Lenze controllers.

Which products are affected?
PLC Designer from V3.6
Lenze 3200C and p500 controller from firmware V3.6
ECSxM compact servo with EtherCAT AIF interface

Short-term measures/recommendations:
Do not operate an ECSxM compact servo at the EtherCAT interface of the Lenze 3200C and p500 controllers with firmware version V3.6 or higher.

Evaluation:
From control system release V3.6 onwards, the ECSxM compact servo is no longer supported by the Lenze 3200C and p500 controllers. The drive can, however, still be configured in PLC Designer V3.6.


URL for linking this AKB article: /en-de/go/akb/201400127/1/
森林舞会游戏