Saving the I/O 1000 parameter set to the boot project of the controller

Function extension:
When clicking the <Save parameter sets...> button in the toolbar of the PLC Designer, the parameter sets of the devices connected to the controller will be uploaded online to the controller and saved in the boot project of the controller. When the controller is restarted, these parameter sets will be automatically downloaded from the controller to the corresponding devices. The following Lenze devices support this function:
  • EPM-S110 (I/O system 1000 CANopen bus coupler) new* 
  • EPM-S130 (I/O system 1000 EtherCAT bus coupler) new*
  • i700 (servo inverter - single and double axis)
The function is also supported by the EASY Starter. When saving the parameter set in the controller (<Save parameter set to device (F6)>) the parameter set of the controller will be saved fail-safe and the device parameter sets will be uploaded and saved fail-safe in the boot project of the controller.
 
To ensure that the parameter sets can be saved in the controller, a boot project must be available in the controller and the controller must have been started with the boot project. 
 
Contained in which products?
PLC Designer V3.12
EASY Starter V1.9
c300 controller V3.12
3200 C controller V3.12
p300 panel controller V3.12
p500 panel controller V3.12

URL for linking this AKB article: /en-de/go/akb/201500858/1/
森林舞会游戏