Trace recording stops unintentionally (corrected from V3.18)

Corrected from:
PLC Designer V3.18
 
Response of the new version:
When opening the 'Manual control' dialog (previously 'Manual motor direction of rotation check') or opening the controller logbook or the logbook of a drive, ongoing trace recording processes are continued.
 
What happens?
Trace recording started in the PLC Designer stops.
 
When does this behaviour occur?
Trace recording started in the PLC Designer stops ...
  • ... if the 'Manual motor direction of rotation check' dialog is opened or the function is started. 
or
  • ... if the 'Logbook' dialog of the controller or a drive is opened.
After closing the dialog, tracing can be started again.
 
Which products are affected?
PLC Designer 3.3.2
 
Short-term measures:
Use the EASY Starter to open the 'Manual motor direction of rotation check' or the 'Logbook' dialog to ensure that running tracing processes are not stopped.
 
Evaluation/recommendations:
Opening dialogs in the PLC Designer may stop trace recording started in the PLC Designer. 
 

URL for linking this AKB article: /en-de/go/akb/201600107/1/
森林舞会游戏