i700 motor commissioning: Pole position identification cannot be started via button (corrected from V3.14)
?Corrected from: PLC Designer V03.14 (update via EASY PackageManager)
Response of the new version:
The button in the "Motor Commissioning / Feedback System" dialog works properly.
The button can be used to start pole position identification in the i700.
What happens?
Pole position identification (i700 commissioning function) cannot be started via the button in the "Motor Commissioning / Feedback System" dialog. The button is not active (grey).
When does this behaviour occur?
Always.
Which products are affected? PLC Designer
Short-term measures:
Use the Easy Starter. The button in the commissioning dialog works properly there.
