Exception when starting the PLC Designer (corrected from V3.15)

Corrected from:
PLC Designer V3.15
 
Response of the new version:
When starting the PLC Designer, the below-described exception no longer occurs.
 
What happens?
The following exception occurs when starting the PLC Designer:
Screenshot.png 
 
When does this behaviour occur?
The exception may occur if a third-party software has been installed and, during installation, a version older than V2.1 of the 'Microsoft.Practices.Unity' assembly has been installed in the Windows Global Assembly Cache (GAC).
 
Which products are affected?
PLC Designer from V3.0
 
Short-term measures:
Contact the Lenze Service and state the ticket number 8000030907.
 
Evaluation/recommendations:
The PLC Designer can no longer be started. The function restriction is very rare and cannot be removed by reinstalling the PLC Designer.

URL for linking this AKB article: /en-de/go/akb/201700096/1/
森林舞会游戏