Cam editor: No valid licence (corrected from V3.16)

Corrected from:
PLC Designer V3.16
 
Response of the new version:
If the 'EASY Professional' licence is installed on your PC, you can add and edit objects in the PLC Designer using the CAM editor ('MotionObjects' object). 
 

What happens?

  • In new projects, it is not possible to add objects (e.g. curve tracks) to the 'MotionObjects' object in the device tree.
  • In existing projects, the following message appears when opening objects (e.g. a cam track) in the 'MotionObjects' object in the 'Objects' tab:
    Please install the licence required for the Cam editor.

When does this behaviour occur?

The above-described behaviour occurs if the 'EASY Professional' licence is installed on your PC.

Which products are affected?

PLC Designer V3.15

Short-term measures:

Install the software attached to this article. For this, proceed as follows:

  1. Save the zip file to any directory on your PC:CamEditor_SupportProfessionalLicense.zip (1.49 MB)
  2. Unpack the zip file in any directory on your PC.
  3. Start the Setup_Hotfix.msi file from this directory.
    After this, you can use the Cam editor with the 'EASY Professional' licence.

Evaluation/recommendations:

Despite a valid 'EASY Professional' licence, the Cam editor of the PLC Designer cannot be used. A remedy is described under "Short-term measures".


URL for linking this AKB article: /en-de/go/akb/201700305/1/
森林舞会游戏