Corrected from:
PLC Designer V3.20
Response of the new version:
The PLC project can be translated without errors despite a changed default value of a user parameter.
What happens?
When translating a PLC project the following error message appears
Error in attribute 'LenzeParamDefault_' of POU"
The PLC project cannot be loaded into the controller.
When does the behaviour occur?
The behaviour described occurs when a user parameter is created in the PLC project with a pragma and the default value of this parameter is changed by the pragma,
e.g.: {attribute 'LenzeParamDefault_203' := 'Index="20752", SubIndex="32", Value="2" '}
Which products are affected?
PLC Designer V3.x
Short-term measures:
Before compiling the PLC project, execute the menu command 'Clean all' (menu 'Build'). Afterwards the PLC project can be compiled without errors.
Evaluation/Recommendations:
User parameters can be created in the PLC Designer with the help of pragma instructions. After changes in these pragma instructions, the menu command 'Clean up all' must always be executed.
Automatic Translation
