Parameter values change sporadically by clicking on them (fixed as of V3.21.1)

Corrected from:
PLC Designer V3.20.2, V3.21.1
 
Response of the new version:
By clicking on different parameter values in the parameter list, the respective parameter value does not change.
 
What happens?
After clicking on a value of a parameter in the parameter list, the value of the parameter changes.
 
When does the behaviour occur?
If you click on the values of different parameters in the parameter list of the controller, the value of a parameter may change unintentionally.
 
Which products are affected?
PLC Designer V3
 
Short-term measures:
If possible, edit the parameters using other dialog tabs.
 
Evaluation/Recommendations:
Install the Service Pack 1 for PLC Designer V3.21

Automatic Translation

URL for linking this AKB article: /en-de/go/akb/202000130/1/
森林舞会游戏