PLC Designer: "Format change" in the dialogue "Field device parameters have changed...". (corrected from V3.23)
Corrected from:
PLC Designer V3.23
Response of the new version:
When going online with the PLC Designer, the dialogue "Field device data has changed" no longer appears with the entry "Format change" if a boot project was previously created on another controller with the same project.
What happens?
When going online with the PLC Designer on a control, the dialogue "Field device data have changed" appears with the entry "SoftPLC parameters, generated parameter description, format change".
Whe does the behaviour occur?
First, a boot project is created on a controller with the PLC Designer. Then a boot project is created with the same project on another controller. If you switch back to the first controller and go online again, the dialogue mentioned above appears.
Another scenario:
The source code is transferred to the controller with the PLC Designer and read back from another PC at a later time.