?Corrected from:
PLC Designer V3.24
Response of the new version:
The Safety Parameter Editor is also displayed when the same PLC Designer version (from V3.24) is installed on the PC again.
What happens?
The Safety Parameter Editor of the i950 Servo Inverter is not available in the PLC Designer project.
When does the behaviour occur?
The Safety Parameter Editor is no longer available if a PLC Designer version is uninstalled and the identical version is later reinstalled.
Which products are affected?
PLC Designer from V3.0
Short-term measures:
Contact Lenze.
Evaluation / recommendations:
The function restriction is immediately noticeable when the Safety Parameter Editor is used in the PLC project. It occurs if the same version of the PLC Designer has been installed more than once on a PC. If the Safety Parameter Editor is not required, this function restriction has no further effect on the PLC project.
Automatic Translation